Microsoft Teams Meeting ID: 263 528 869 321Īny party wishing to provide data, views, or arguments regarding the proposed revised rules in writing may do so by submitting them to: Rusty Haygood, Community Development and Finance Division, Georgia Department of Community Affairs, 60 Executive Park South, N.E., Atlanta, Georgia 30329, or by emailing comments to These written comments should be received no later than 5:00 P.M. The Microsoft Teams meeting can be accessed using the following login information The meeting will be held at 11:30AM on Octovia a Microsoft Teams Virtual Meeting. The hearings will afford all interested persons reasonable opportunity to provide data, views, or arguments regarding proposed rules for the Georgia Minimum Standard Codes Appeals Subcommittee (Rules of the Georgia Department of Community Affairs, Chapter 110-11-2, et seq.). (The possible junction types vary depending on whether the clicked element is a Duct, a Cable or a Pipe.Notice is hereby given that the Department of Community Affairs will hold public hearings in accordance with the Administrative Procedures Act, O.C.G.A. Duct Tee, Duct Takeoff, Duct Wye), then click OK. The Insert Junction Element dialog box appears.Ĭhoose the type of junction you wish to insert (e.g. Click on the centerline of a placed MEP elementģ. Click Start Routing on the MEP Routing paletteĢ. You can begin a Routing operation by placing a junction (Tee, Take-off, Wye) at an already placed straight MEP segment.ġ. Instead, switch the Construction Method (use the MEP Routing palette or the Tracker) to Vertical Rise and place the next element.) (If you prefer that the next placed element be vertical, do not choose any of the four horizontal directions indicated by the on-screen feedback. As applicable: Guide Lines will prompt you to click to define the angle at which to continue the next routing element. Click in one of these four positions to choose the desired geometry.ĥ. Depending on where you clicked and the junction type, additional clicks may be necessary: move the cursor around to see the possible positions: should it branch off the right, left, top or bottom of the duct?.Ĥ. Note: To place a Take-off, click on the element centerline.ģ. Click on the existing element - the centerline or its endpoint - to place the junction. Activate the desired Junction tool (Tee, Wye or Take-off).Ģ. Junctions cannot be placed on grouped elements.ġ. Note: Make sure the Autogroup function (Edit > Grouping > Autogroup) is turned off. Generally, you will add junction-type MEP elements to an already placed, straight MEP element. Junction-type MEP tools are the Tee, Wye and Take-off.
0 kommentar(er)
